EVO rear Toe Arm - set (billet)
Billet EVO rear toe arm set. Comes with spacer to suit EVI 6-9 or EVO X.
(MSImit02-00-054 is discontinued and included in this kit)
This product is no longer in stock
When adjusting the ride-height of the car or fine tuning your alignment settings these arms simplify the task by allowing a much wider range of settings compared to OE parts.
Our rear toe arm adjustment kits allow for a more precise adjustment of toe on the rear suspension over the stock units. Machined from T6-6061 aircraft grade aluminum, the billet parts are lightweight while increasing the rigidity of the part required for motorsport use. The inside end uses our motorsport heim joints with a PTFE liner for quiet operation, where the outside end features our serviceable HD Tie-Rod ends. This eliminates any chance of bushings binding while the suspension arm is in motion.
These arms will provide a much crisper feeling and increased feedback with less flex and distortion compared to other manufactures or OE parts. Suitable for both on and off-road applications, they bolt up to original equipment. The bearings and rod ends are of the highest quality available on the market, to allow extended intervals between servicing.
With two versions of these toe arms available, tubular for strength or billet for weight saving, they allow a wide range of adjustments.
As always, all MooreSport products have a lifetime warranty, even in motorsport applications, against any manufacturing defects
- Servicable Tie rod ends
- Suitable for street or motorsport use
- All metric hardware
- Includes spacers to suit ALL EVO platforms (6-9 / X)
- Approximately 40mm range of adjustment